Skip to main content

SnapPlate+ Instructions for 2023+ Cybertruck

Step 1

Install your license plate using four of the included black or silver torx security screws.

SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing the license plate screw installation

Step 2

Press the OPEN button on the right side of the base part.

Step 3

Insert into the center of the grille making sure the vertical bar is aligned with the vertical slot in the SnapPlate.

SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing the opening in the base for the vertical bar in the grille

Step 4

Press the CLOSE button on the left side of the base.

Important! If the button is too difficult to fully close or the SnapPlate feels loose on the grille after it is closed, adjust the rotating latches following the Grille Depth Adjustment instructions. ☝️

SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing how to push the close button

Step 5

Make sure the CLOSE button is flush with the SnapPlate body to ensure it is locked in place with the magnets engaged.

SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing the push to close button in the closed position

Step 6 (Optional)

Tighten the black anti-theft security screw in the hole on the right side.

If you find that tightening the screw moves the OPEN button, push and hold the CLOSE button on the left side while tightening the screw.

Note: It should take ~6 full turns to lock or unlock the screw. It does not need to be fully removed when unlocked.

SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing the security screw on the lower right side

Step 7 (Optional)

Once the screw is tight, double-check that the open button is flush and does not move.

SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing the push to open button on the right side

Step 8

Don’t forget to remove SnapPlates for automated car washes. Most touchless washes are fine, but better to be on the safe side!

SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing removal for a car wash

Step 1

Remove the T10/T25 bit from the screwdriver handle and reinstall with the smaller T10 bit facing out.

Step 2

Locate the T10 torx screws in the center of each rotating latch.

  • Go to Step 3 to loosen latches
  • Go to Step 4 to tighten latches
SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing the location of the grille adjustment screws

Step 3

Turn each screw counterclockwise (lefty loosey) 1/2 turn to loosen the latches by 0.25mm. Pull each latch with your fingers to make sure they are extended and then try the fit on the grille.

Repeat up to four times (two full turns) as needed.

Important! Contact support before proceeding past two turns. If loosened more than two turns, the SnapPlate could become stuck in the grille and it may be very difficult to remove.

SnapPlate Plus front license plate holder for the 2023+ Cybertruck showing how to loosen the grille adjustment screws

Step 4

Turn each screw clockwise (righty tighty) 1/2 turn to tighten the latches by 0.25mm and try the fit on the grille.

Repeat as needed.

This field is for validation purposes and should be left unchanged.