License Plate Reindeer Kit

$35.00$40.00

  • Works with most vehicles (some vehicles may need alternate screws)
  • Mounts using the four license plate screws
  • Works with SnapPlates for quick installation and removal (remove for car washes!)
  • Made in USA from weatherproof, 3D-printed, PETG plastic

Description

Make your car festive with our license plate reindeer kit!

It uses the same four screws as the license plate to hold the antlers on top and then to hold a bracket on the bottom that the nose screws on to, so it’s pretty simple to install. It works with our SnapPlates for quick installation and removal on Teslas, but also works with the factory plate mount or other aftermarket plate mounts on most any vehicle as long as there’s room around the plate for the nose and antlers without hitting anything.

To make sure there’s plenty of clearance between the antlers and the bumper, we leaned them out several degrees and we used a GoPro with our accessory mount at various speeds and conditions to make sure they’re ok. Since they’re 3D printed, we’re able to make the insides mostly hollow, but with an internal grid structure, so that helps keep the weight down while still being rigid and since they’re plastic you don’t have worry about rain.

Of course these don’t have any special powers so they’re not going to make your sleigh fly and the nose isn’t going to guide your sleigh by night, but we haven’t seen any issues with the parking sensors or Autopilot, so Autopilot will continue guiding your sleigh just fine on its own.

Every kit is designed, printed, and assembled in California. We strive to reduce our environmental impact by using recycled plastics that are Made in the USA and by using Prusa 3D printers to make strong parts with internal structures that optimize our use of plastics.

Reviews

There are no reviews yet

Be the first to review “License Plate Reindeer Kit”

Your email address will not be published. Required fields are marked *